POLLYSEAL -THE DESIGN INFORMATION About Us | Contact Us | Home  

Pollyseal Waterproof Membranes
The range of Pollyseal waterproof membranes are laminates of various plastic films and reinforcements coated with bitumen/polymer adhesives to provide a tough self-adhesive waterproof membrane sheeting.

Pollyseal G.M.A membrane is available to protect against methane and landfill gases from contaminated sites and natural gases such as radon. Also available is Solar Shield. a Pollyseal membrane that uses an aluminum backing to offer solar protection.

All of the products are manufactured to the highest standards. Individual properties of the products are tested to BS, DIN and ASIM test methods. Pollyseal membranes are used world-wide by many civil engineering and construction companies. The Company is represented throughout the world and its technical sales personnel regularly travel overseas to provide support and back-up service where required.

A - Pollyseal Bitumen Mastic or other approved sealant
B - Pollyseal Solar Shield
C - Pollyboard "O" series protection board
D - Insulation screed shingle or paving
E - Pollyseal self-adhesive membrane reinforced at corner.
F - Pollyseal fillet

USES
Waterproofing Gas Proofing
Foundations
Basements
Roofs and Plaza Decks
Lift Shafts, Pits
Service Reservoir Roofs
Car Park Decks
Bridge Decks
Subways
   
Landfill Sites
Radon affected areas
Redeveloped contaminated sites such as town gas works
Tunnels
   
   
DESCRIPTION

Building structures need protection from their environment, either to prevent the ingress of water into the building or to stop waterborne salts from entering and attacking the concrete structure and its reinforcement. For many years bitumen has served this purpose well but modern building techniques demand higher performance in mechanical properties together with faster and situation tolerant installation properties.

Pollyseal waterproof membranes use the good waterproofing characteristics of bitumen, modified with polymers to produce a strong adhesive with rapid bonding ability and a wide ranging temperature tolerance. The backing is then combined with the adhesive to improve the mechanical properties including resistance to puncturing. By varying the type and thickness of backing the mechanical properties are tailored to application requirements

Advantages Product Features
Factory controlled thickness
Rapid sealing and bonding
Fast and easy application
No heating or drying
Self sealing
High resistance to water pressure and water vapour transmission
High puncture resistance
Manufactured by a BS 5750 registered company
Manufactured to conform with UK Water Byelaws Advisory Service listed certificate Scheme
Manufactured to British board of agreement standard classification
Manufactured to BS/EN/ISO standard
Supplied with a Selvedge strip to promote lap adhesion
Highly resistant to gas permeation
QUALITY
Pollyaim’s range of products are manufactured to a high quality that is rigorously maintained during all aspects of their manufacture.

BUILDING REGULATIONS
Pollyseal Waterproof Membranes conform in all aspects to Building Regulations and standards for England. Wales. Scotland and Northern Ireland.

[ Pollycote | Politt | Pollatum | Mastics | Rockshields | Pollyseal | Inspection and Wrapping Machines ]

P o l l y a i m
313-B, Ballards Lane, London N12 8LY, United Kingdom
Tel: +44 7518921274 Email: info@pollyaim.co.uk, Visit us at www.pollyaim-ltd.com

Pollycote, Pollyseal, Politt & Pollatum are trademarks of Pollyaim Ltd. All rights reserved, Copy rights 2016