|
Politt - 75 is a polyethylene backed, pressure sensitive,
adhesive outerwrap, designed to provide permanent mechanical protection
when applied simultaneously with an inner primary coating.
Politt - 75 can be used as an outerwrap on any known coating
system. It was specially designed to be used over Politt, Pollycote,
and Pollatum range of tapes to provide maximum protection to
the inner layer from potential damage from back-fill and soil
stresses.
|
PHYSICAL
PROPERTIES
|
|
Colour
Thickness Total
Backing & adhesive thickness as per customer requirements
Tensile strength
|
Black or white (other
colours available)
10, 15, 20, 25, 30, 35, 40 mils available
20 to 55 Lbs./In. width |
| COMPOSITION |
Baking
Adhesive
Elongation
Adhesion to backing |
Polyethylene
Pressure sensitive
300 % minimum
3.5 Lbs./In. width |
| TEMPERATURE
RANGE |
Normal application (Ambient)
Normal service (Operation) |
-30 to 160 deg.F
-30 to 185 deg.F |
| ELECTRICAL AND
MOISTURE RESISTANCE |
Dielectric strength (ASTM D - 1000)
Insulation resistance
Dielectric strength is not a suggested holiday
Detection voltage. For recommended holiday
Detected voltage refer to nace standard RP-02-74 |
1000 Volt/mil
1,000,000 megohms |
* All test results by ASTM D-1000 wherever applicable.
* All test results are correct at time of print.
The information detailed in this Data Sheet is subject to modification
from time to time in light of experience and or product development.
Before using, customers are advised to check with Pollyaim Ltd.,
quoting the reference number.
All figures were indicative when data sheet went to press.
|